At this stage you will need an assistant.

On a large table or on the floor, it is necessary to spread the sheets of waste paper, and on them to put the wallpaper themselves. You should take no more than ten from the chopped panels and lay them on each other, retreating about two centimeters from the upper edge. If the picture of the wallpaper has the top and the bottom, then now you need to ensure that they are laid in accordance with this. Next, the upper sheet is smeared with glue diluted according to the instructions on the package. To do this, it is convenient to use a roller or painting brush. They begin to spread the sheet from the middle, as if dispersing the glue to the edges. It must be remembered that just the edges must be smeared most carefully, although in fact the glue should be distributed evenly. Be careful — if the glue falls on the front side of the wallpaper, then ugly dirty spots will remain on them. Next, the panel must be carefully folded in half in the lubricated surface inside and shifted to some clean place (it is better to prepare it in advance): the wallpaper must be carefully saturated with glue. Impregnation time depends on the type of wallpaper and their thickness. Paper wallpaper, one — and two -layer should lie down for about 6 minutes, wallpaper on a paper basis, but with some other external coating they require a little more time — about eight minutes. But wallpaper from non -woven in impregnation do not need at all, you can smear with glue — and immediately on the wall. Nebumber wallpapers, that is, those that go a non -woven basis and do not smear from fiberglass at all — it is applied to the walls, and then the wallpaper is glued to it. There are several dangers: firstly, paper wallpaper well-soaked glue can simply spread in their hands, like any wet paper; Secondly, wallpaper with silkography and vinyl wallpaper must be impregnated with glue especially carefully — in dry form they are very afraid of creases that are perfectly visible on their texture. When a sheet of wallpaper is finally saturated, you can start glue. At this stage you will need an assistant. One of the employees carefully, so as not to stain, not to hush and break, takes a sheet of wallpaper rolled in half, rises with him on a ladder and unfolds there. While the first puts a sheet of wallpaper to the marked line at the ceiling, the second straightens it from below. This will help to avoid creases, bubbles and wrinkles. Further, the panel should be gently smoothed out of the center to the edges, and glue. If he performs, you need to wipe it instantly with a dry clean rag, otherwise the spots will remain. It is convenient to smooth the wallpaper on the wall with a brush or a clean roller. The remaining sheets are glued according to the same principle.