Dim Lights

Dim Lights

The design is assembled from the panels themselves, intermediate profiles, aluminum corners and galvanized supporting suspensions and tires. Since the installation of the rack ceiling with your own hands is not so difficult to do it, the first thing to do is to go to the store. First, make clear ceiling measurements. The measurement should be made taking into account the stock of 1-2cm on each side and if the corners are more than the usual 4, you will have to take an additional supporting tire. Having received the collected purchase, you should calculate and make sure all the necessary details of the river ceiling are available. You should start the installation of the rack ceiling with your own hands by marking. The distance is especially distinguished by which the ceiling should be released, since this distance should be enough to accommodate spotlights. Even if there are no lamps, it is recommended to lower the ceiling by 10-15cm. We draw horizontal markings along the entire perimeter of the room, then the end profiles will be fixed on this markup. Every 30-50cm we drill holes in the wall and mount the profile. Next, the supporting tire is mounted, since they usually go more length than they need, then cut off the excess scissors so that the tire starts with fasteners for the panels. Next, you should try on the end profiles of the elements and carefully make cuts on the upper edges of the profiles so that it is possible to season the supporting tires into the made slots. The tires should be removed from the edge of the walls by 25-30cm, otherwise the installation will be quite difficult. Further, the tires are fixed using suspensions to the ceiling so that they are in slightly limbo and do not lie on end profiles. Next is easier work, you need to cut and fix the rack panels on the assembled structure. The easiest way to perform this task will be measured the panel from the edge of the wall to the opposite edge of the end profile. Having cut off several intermediate profiles and panels, you can proceed directly to the installation itself. To do this, the edge of the first element is started in the groove of the end profile, after the reverse movement to start in the groove of the opposite profile somewhere by 0.5-1 cm and is clipped in the tire attachment. After an intermediate profile is inserted after. According to this scheme, continue to collect the remaining ceiling. But, there is one thing, but, in the assembly of any rheck ceiling, even expensive, the panel will not fit tightly with the end profile. This position can be changed using a 1-2 centimeter piece of the intermediate profile of the ceiling tucked on the inside, this will play the role of the spring. The most difficult will be the fixing of the last panel. In order to correctly measure and put this panel, cut the next panel, fix it and attach an intermediate profile, now you can make the correct measurements. Cutting off the excess, do not be scared that it turns into a spiral, after installation the surface is leaving. The already prepared panel is cut into the end profile with a cut edge, fixing the intermediate. An intermediate profile will come to the aid of the resulting gap. You just have to piss the edge of the panel in the end profile with slices of the profile. It remains only to finish the assembly of the ceiling with fixing the last profile.