Replacing the box machine

Automatic transmission of any car is a rather complicated mechanism. The device of the automatic gearbox gearbox is not only more complicated than the mechanical transmission, but also more difficult to arrange than many other mechanisms in the car. And in some cases, it is much more technological and more complicated than the engine of the internal combustion of the car. In this regard, any work associated with an automatic transmission is a laborious process. Automatic transmissions of most automobile brands are quite strong and reliable in operation of the device. Damage of automatic transmission can occur for several reasons, the main ones are considered to be improper operation (caused by ignorance) or ignoring the terms recommended by the manufacturer for maintenance, replacement of consumables and repair. For example, if you switch the box to the “N” position from the “D” position during the movement of the car, then you can randomly enable the “r” or “p” mode.Replacing the automatic gearbox is associated with some difficulties. Consider some of them. In order to finally determine and decide to replace the gearbox, consult with specialists. Automatic transmission specialists are at almost any maintenance station. First you need to diagnose automatic transmission and then decide what needs to be replaced, with what spare parts (which manufacturer), and of course about the cost of replacing. It is necessary to discuss and coordinate all organizational points. To determine the spare parts is also a not unimportant factor that should be taken into account by the motorist. At a conscientious service station, they will not change the cost after the work performed — it is fixed and unchanged. Mars AVTO carries out comprehensive maintenance, repair and replacement of automatic gearboxes. Replacing the box of the machine is carried out only by highly qualified specialists who will quickly identify and eliminate the problems of your car in the automatic transmission. The main chain from which the process of repairing and replacing the automatic gearbox can consist of:- primary diagnostic work.- Removing the box — phased analysis of automatic transmission with subsequent fixation of breakdowns of mechanical or electronic parts.- Coordination, which includes is the approval of the replacement of spare parts, the cost of the work performed.- Repair work (if necessary, a complete replacement of the gearbox) in some cases, replacing the box of the machine is cheaper than the repair of its main components and mechanisms.